The software provided on this page ("SOFTWARE") is driver software exclusively for ADC's measuring instruments that use USB interface.
When downloading the SOFTWARE, read the following "SOFTWARE License Agreement." By installing the SOFTWARE, you agree to be legally bound by the terms of this SOFTWARE License Agreement.
SOFTWARE License Agreement
All rights in and to the SOFTWARE (including, but not limited to, copyright) shall be and remain vested in ADC Corp.
(1) You may not copy, modify, or change, all or any part of, the SOFTWARE without permission from ADC Corp.
(2) You may not reverse engineer, de-compile, or disassemble, all or any part of, the SOFTWARE.
ADC Corp. is not liable (1) for any SOFTWARE failures which may arise out of any misuse of the SOFTWARE (misuse is deemed to be use of the SOFTWARE For any purposes other than those described in the manual) or (2) for any dispute between you and any third party for any reason whatsoever including, but not limited to, infringement of intellectual property rights.
The SOFTWARE is governed by the laws of Japan.
Customer support from ADC Corp.
ADC Corp. does not provide any customer support for the SOFTWARE.
Before Using ADC Instruments USB Driver
The interface of ADC's measuring instruments is set at factory shipment as shown below. When controlling the measuring instruments by using the USB driver, set the interface to USB according to each model. For how to select the interface, refer to the Operation Manual of each model.